1 x ATX Control Cable (Cable Length: 47cm / 18.50 inch). 1 x USB-A to USB-C OTG Cable (Cable Length: 100cm / 39.37 inch). PiKVM-A4 Kit2 (for users who have purchased X630 module already) PiKVM-A4 Kit1 (for Raspberry Pi Zero 2W users) Power Input: 5.1Vdc +/-5%, ≥3A (Power Via USB Type-C port of X630-A4), Recommend Geekworm 5V 4A 20W USB-C PSU. Reserves the 4pin header & spacers for I2C OLED display. ATX control via RJ45 connector Switch the machine on or off, reset it, and monitor the status of HDD LED & power LED remotely. Equipped with solidstate relays to protect RPi GPIO pins from computer and ESD spikes. 
Hardware Real Time Clock (RTC) with CR1220 coin battery socket.OTG Keyboard & mouse Mass Storage Drive emulation.
HDMI Full HD capture based on the TC358743 chip.Control a server and computer using a web browser.Compatible with Raspberry Pi Zero 2 W Only ( Not support Raspberry Pi Zero W because PiKVM OS is no longer support Pi Zero W)).Designed especially for PiKVM ( Raspberry Pi based KVM over IP).DON'T use raspberry pi's OTG port as it is occupied, please use OTG port on X630-A4.We need to ensure you isolate the 5V connection between the Raspberry Pi and host PC to prevent backpower issues that can cause instability or damage to either the host PC or the Pi.USB-C to USB-A cable only with DATA lines (for keyboard and mouse emulation), Using other cable might cause instability or damage to either the host PC or the Pi. Please use the supplied USB Type-C to USB 2.0 A-Male Cable only.Ethernet Cable (TIA/EIA-568.B connection, and it's ATX control signal cable).0.96 inch OLED (for display, Resolution: 128×64 pixel).
X630-A5 Adapter Board (it is installed inside the PC case, and it connect the computer motherboard and IO panel cabe of PC case). X630-A4 Expansion Board (for ethernet, cooling, RTC, power in etc). X630 HDMI to CSI-2 Module (for video capture). The whole PiKVM-A4 kit is composed of follow parts: This PiKVM-A4 kit is designed and based on Raspberry Pi Zero 2 W ONLY. It's true hardware-level access with no dependency on any remote ports, protocols or services! You can use your remote keyboard and mouse or PiKVM can simulate a keyboard, mouse, and a monitor, which are then presented in a web browser as if you were working on a remote system directly. PiKVM ( ) is a very powerful and Open Source Software which allows for a remote connection via your Raspberry Pi to turn on/off or restart your computer, configure the UEFI/BIOS, and even reinstall the OS using the Virtual CD-ROM or Flash Drive.
0 kommentar(er)
